Steam Coil Large Capacity Steamer, 2 Compartments, 36″ Cabinet, 115V

Product Overview

The SCDA-2 and SCDA-3 are a pressure compartment cooker with top compartment selectable switch to operate in pressureless free venting mode, regenerative steam coil boiler, c-CSA-us and NSF Certified, ASME code stamped, National Board registered.The cooker is constructed of all-welded type 304 #4 finish stainless steel. The doors shall be of all welded one piece welded stainless steel outer shell with a removable inner liner of aluminum plate with full perimeter gasket seal with a wheel-and-screw closing mechanism. The doors shall open a full 180° and latch upon closing.

The compartments shall have a clear opening of 10-1/4” x 26-3/8” (260 mm x 670 mm). Compartment operation shall be at a maximum pressure of 6 p.s.i. (41 kPa).Each compartment shall be provided with universal pan supports. Each optional sliding shelf will support two full size (1/1 gastronorm) pans.

The control housing shall be constructed of #4 finish stainless steel with a full-access removable panel. Each compartment shall be independently controlled by an automatic timer control with visible and audible signals. At the end of the cooking cycle the controls automatically shut off incoming steam, vent pressure and drain condensate from the compartment with a continuous audible signal until turned off manually.

The compartment cooker shall be mounted on a cabinet base with full perimeter angle frame, reinforced counter, regenerative steam coil boiler mounted complete with controls, hinged doors and 6” (152 mm) stainless steel legs fitted with 4 adjustable flanged feet. Exterior shall be stainless steel #4 finish with removable side panels for easy access to boiler.



  • Manual controls
  • Automatic timers
  • Split water lines
  • Universal pan guides
  • Direct Steam c/w PRV pressure reducing valve
  • “Y” strainer
  • 36” Cabinet Base


  • 220 or 240 VAC, 1 Phase ,50 Hz (GBVS-1)
  • Load compensate timer (LCT)
  • Stainless steel back panel (SSB-)
  • Stainless steel frame (SSF-)
  • Correctional package
  • Ball float trap (BFT)
  • Water in “Y” strainer (condenser feed)
  • Single pantry 68” spray hose and bracket (SP-RSH)
  • Double pantry 68” spray hose and bracket (DP-RSH)
  • Sheet pan support (SPS-PC)
  • Wire shelf rack (SSR-PC)



Request a Quote