OPTIONAL ITEMS AT EXTRA COST
- 220 or 240 VAC, 1 Phase, 50 Hz
- Stainless steel frame
- Stainless steel back on cabinet
- Load compensate timer
- Sheet pan support (SPS-24-1)
- Ball float trap (BFT)
- Spray and rinse assembly
The DCX-24 is constructed of satin finish stainless steel, type 304, with a cooking chamber of one piece all welded 316 stainless steel. The doors have a removable inner liner of stainless steel with full perimeter gasket seal, an outer liner of one-piece all welded stainless steel and a positive lock and seal mechanism. The door opening shall be 17.625” x 26.75” (448 x 680mm). The steamer is provided with removable stainless steel pan supports and a stainless steel drip trough connected to drain in order to collect condensate when door is opened.
The control housing is constructed of stainless steel with a full access removable panel. The timing of each cooking compartment can be independently controlled by a “60” minute timer, a green ready pilot light and a red cook pilot light. At the end of the cooking cycle an audible signal is sounded. Steam flow to the cooking chamber is interrupted when the door is opened during the cooking cycle and shall reactivate when the door is closed.
The convection steamer is mounted on a cabinet base with full perimeter angle frame, reinforced counter, pressure regulator and condensate drain assembly complete with controls for its operation, all stainless steel exterior, hinged doors and 6” (152mm) stainless steel legs with 4 adjustable flanged feet for securing unit to floor.