The DDA-2 and DDA-3 are constructed of all welded type 304 #4 finished stainless steel. The doors have a removable inner liner of aluminum plate with full perimeter gasket seal, an outer liner of one piece welded stainless steel and a wheel and screw closing mechanism. The doors with a clear opening of 10-1/4” x 26-3/8” (260 mm x 670 mm) latch upon closing and open 15° upon latch release. Compartment operation has a maximum pressure of 6 psi (41 kPa).

The control housing is constructed of #4 finish stainless steel with a full-access removable panel. The timing of each compartment is independently controlled by an automatic timer control with visible and audible signal. At the end of the cooking cycle, the controls automatically shut off and exhaust the incoming steam, drain the condensate from the compartment, and sounds a continuous signal until turned off manually.

The top compartment acts as either a pressure-less free venting cooker or a pressure cooker operating at a maximum of 6 psi (41 kPa) as selected by the operator. Top compartment is supplied with a mode selector switch. Each cooking compartment comes standard with universal pan supports.

The compartment cooker shall be mounted on a cabinet base with full perimeter angle frame, reinforced counter, hinged doors and 6” (152 mm) stainless steel legs fitted with 4 adjustable flanged feet for securing to the floor. Exterior shall be stainless steel #4 finish with removable side panels.

  • BUY NOW online with our Click & Brick dealers below
  • For equipment guidance click Find Local Dealer
  • For equipment demonstrations click Find Local Rep


Direct non-toxic steam, incoming at a minimum of 15 psi (103 kPa) with a flow of 150 lbs. (68 kg) per hour. A pressure reducing valve provides compartment pressure of 6 psi (41 kPa) and control system is provided to cool the condensate drain. The controls are equipped for operation on 115VAC, 1 Phase, 60 Hz.


  • 220-240 VAC operation (specify voltage)(DBVS-1)
  • Stainless steel frame (SSF-)
  • Stainless steel rear panel (SSB-)
  • Correctional package
  • Ball float trap (BFT)
  • Spray and rinse assembly
  • Wire shelf rack (SSR-PC)
  • Sheet pan supports (SPS-PC1 or SPS-PC2)





Scroll to Top
Live Chat