Gas Convection Steamer, 2 Compartments, 16 Pan, 36″ Cabinet Base, 115V, 300,000BTU

Product Overview

The GCX-16 is a convection steamer with gas steam boiler. The steamer is constructed of satin finish stainless steel, type 304, with a cooking chamber of one-piece all welded 316 stainless steel. The doors have a removable inner liner of stainless steel with full perimeter gasket seal, an outer liner of one-piece all welded stainless steel and a positive lock and seal mechanism. The door opening is 14” x 26.5” (356 x 673mm).

The steamer is provided with removable stainless steel pan supports and a stainless steel drip trough connected to the drain to collect condensate when door is opened.

The control housing is constructed of stainless steel with a full access removable panel. The timing of each cooking compartment is independently controlled by a “60” minute timer, a green ready pilot light and a red cook pilot light. At the end of the cooking cycle an audible signal is sounded. Steam flow to the cooking chamber is interrupted when the door is opened during the cooking cycle and shall be reactivated when the door is closed.

The convection steamer is mounted on a cabinet base with full perimeter angle frame, reinforced counter, boiler mountings, gas boiler with controls, all stainless steel exterior, hinged doors and 6” (152mm) stainless steel legs with 4 adjustable flanged feet for securing to the floor. Water treatment system, automatic blow down, CSD-1 boiler controls, electronic ignition, and split water line are standard.



  • 16 Pan capacity
  • Manual controls
  • Stainless steel back on cabinet
  • Split water line


  • Floor protective panel
  • 220 or 240 VAC, 1 Phase, 50 Hz (GBVS-1)
  • Stainless steel frame (SSF)
  • Stainless steel back on cabinet (SSB)
  • Load compensate timer
  • Sheet pan support (SPS-1 or SPS-2)
  • Spray and rinse assembly
  • Water in “Y” strainer (condenser feed)
  • Steam take off kit (STOK)
  • Wire shelf rack (CXSS-16 must order SPS)



Request a Quote